www.HunterFan.com
Advertising
1.888.830.1326
Model #99111
Universal Ceiling Fan
Wall Control
View and Download ALC AWF13 SightHD user manual online. 720p Indoor Pan/Tilt Wi-Fi Camera. AWF13 SightHD IP Camera pdf manual download. Olympus NDT guarantees Model 35 Series Ultrasonic Gages to be free from defects in materials and workmanship for a period of two years (twenty-four months) from date of shipment. The warranty covers only equipment that has been used in a proper manner as described in this instruction manual and has not been subject to.
Getting Started
Wiring the Receiver
Wiring the Wall Control
OR
OR
OR
Remove the canopy. If uncertain how
to remove it, reference the fan’s owner’s
manual. With wiring exposed, it may be
helpful to note existing wire connections or
take a digital photo for reference. Remove
the wire connectors that connect the wires
from the outlet box to the fan, leaving the
grounding wires connected.
CONNECT WIRES FROM
RECEIVER TO FAN -Using the blue wire connectors connect the white wire from the receiver (marked “common out”) to the white wire from fan. Connect the black wire from the receiver (marked “fan out”) to the black wire from the fan. Connect the blue wire from the receiver (marked ”light out”) to the blue wire (or possibly black with white stripe) from the fan. Note: The red wire from the receiver has a pre-installed wire terminator. It will not be used.
If you are uncertain about
wire colors or connections, please contact a qualified electrician.
CONNECT WIRES FROM
RECEIVER TO WIRES FROM OUTLET BOX - Using an orange wire connector connect the black wire (ungrounded) from the ceiling to the black wire from the receiver (marked “live in”). Connect the white wire (grounded) from the ceiling to the white wire from the receiver (marked “neutral in”).
AFTER ALL WIRES ARE
CONNECTED and secured with wire connectors, re-install the canopy.
Before installing the Universal
Remote Control Receiver,
use the pull chains to set the
fan speed to HIGH and the
light to ON. Be sure power is
OFF before proceeding with
installation.
Choose the hanging system that most closely resembles the one used by your fan and install the receiver and wire as directed.
Note: Some fans may have considerable excess lead wire. For easier canopy installation, cut the excess wire, leaving a minimum of 8” remaining. Re-strip the fan lead wires 1/2”. Place remaining excess wire into
the ceiling electrical box. The bracket and fan must remain properly grounded.
You may have installation issues if the fan is installed on an angled ceiling.
Ceiling
Plate
Receiver
Canopy
Receiver
Canopy
Ceiling
Bracket
Receiver
Fan Body
Cable Tie
For low profile fans, the receiver should
be secured to the hanger bracket with
a cable tie.
Receiver
Canopy
Turn the splices upward and push them carefully back through the hanger bracket
into the outlet box. Spread the wires apart, with the grounded wires on one side of
the outlet box and the ungrounded wires on the other side of the outlet box.
To avoid possible electrical shock, before installing or servicing your fan, disconnect the power by turning off
the circuit breakers to the outlet box and associated wall switch location. If you cannot lock the circuit breakers
in the off position, securely fasten a prominent warning device, such as a tag, to the service panel.
M0033-01 • 09/05/12 • © Hunter Fan Company
FR
OM
RECEIVER
whit
e
black
blue
Samsung rugby 4 user manual pdf 2 8. RUGGEDIZED 4G LTE SMARTPHONE User Manual Please read this manual before operating your. All Intellectual Property, as defined below, owned by or which is otherwise the property of Samsung or its respective suppliers relating to the SAMSUNG Phone, including but not limited to, accessories, parts, or software relating there to (the “Phone. Solutions & Tips, Download Manual, Contact Us. Samsung Support CA. View and Download Samsung Rugby 4 user manual online. RUGGEDIZED MOBILE PHONE. Rugby 4 Cell Phone pdf manual download.
whit
e (c
ommon out)
black (fan out)
blue (ligh
t out)
FROM FAN
FRO
M RECEIVE
R
FR
OM CEILING
Instruction Manual
black (ung
rounded)
whit
e (g
rounded)
whit
e (neutr
al in)
black (liv
e in)
OFF
Turn
Pow
er
After removing the switch plate
cover, remove all wiring from
the switch.
Using orange wire connectors,
connect the two black wires
Chefs toolbox pressure cooker user manual. (ungrounded) from the outlet
box. Also connect the two green
or bare wires (grounding) from
the outlet box with the grounding
wire from the wall control.
Insert the wall control into
the outlet box and secure the
two screws using a Phillips
User Manual Template
head screwdriver.
Install the cover plate using a Avcom download psa-37d manual.
Phillips Head screwdriver to
secure the two cover plate screws.
Advertising
Popular Brands
Popular manuals
Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |